A practical reference on DMSO stock: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-05-30 and is reviewed periodically as new material appears.
Laboratory identification of SR9009 typically relies on chromatographic separation coupled to mass spectrometry, often with ultraviolet detection as a secondary check. Nuclear magnetic resonance spectroscopy can confirm molecular structure when a reference standard is available. Because many suppliers sell the compound as a research chemical, independent identity testing is important for experimental reproducibility. A single retention time is not sufficient proof of identity, especially when related compounds may be present. Purity assessments usually report a percentage based on area normalization.
SR9009 is generally described as poorly soluble in water and more soluble in organic solvents such as dimethyl sulfoxide and ethanol. Stock solutions are commonly prepared in an organic solvent before dilution into an aqueous buffer or vehicle. Precipitation can occur if the organic fraction is reduced too quickly or if the final concentration exceeds the compound's solubility limit. Sonication or gentle warming may aid dissolution in some protocols, but excessive heat can promote degradation. Container material and pH can also influence observed solubility.
For long-term storage, SR9009 is typically kept as a solid at low temperature, protected from moisture and light. Desiccated conditions limit hydrolysis, while opaque containers reduce photochemical breakdown. Solutions are less stable than solids and are often stored frozen in aliquots to avoid repeated freeze-thaw cycles. Stability data are not standardized across all suppliers, so users should rely on certificate-of-analysis information when available. Degradation may appear as color change, precipitate, or decreased chromatographic purity.
In laboratory settings, SR9009 is commonly identified by its molecular structure and its interaction with REV-ERB receptors. Vendors may list it under synonyms such as Stenabolic or REV-ERB agonist, but those names do not define purity or identity. Analytical confirmation typically uses high-performance liquid chromatography with ultraviolet detection or liquid chromatography–mass spectrometry. A reference standard is needed to compare retention time and mass spectrum, because the compound can be confused with related research chemicals.
Handling practices for SR9009 focus on minimizing degradation and contamination. The solid is generally stored desiccated at or below -20 °C, protected from light and moisture. Stock solutions are often prepared in dimethyl sulfoxide or ethanol, then aliquoted to avoid repeated freeze–thaw cycles. Aqueous solubility is low, so formulations for animal studies may require cosolvents or suspending agents. Personnel should follow institutional chemical safety procedures, because toxicological data for humans are incomplete.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Visual inspection is not sufficient for identity. |
| Solubility | Soluble in DMSO and ethanol | Low solubility in water; stock solutions use organic solvent. |
| Storage | -20°C, desiccated, protected from light | Limits hydrolysis and photodegradation. |
| Analytical method | HPLC-UV/MS | Used for identity and purity assessment. |
| Synonyms | SR9009, Stenabolic | Naming varies by supplier. |
SR9009 is a synthetic small molecule studied as an agonist of the nuclear receptors REV-ERBα and REV-ERBβ. These receptors help regulate circadian rhythms and metabolic gene expression. In laboratory experiments, SR9009 binds these receptors and alters transcription of genes involved in lipid handling, glucose metabolism, and mitochondrial function. It is not a naturally occurring compound and has no approved therapeutic use. Research interest stems from its ability to modify energy metabolism in cells and animal models.
In rodent studies, SR9009 has been reported to increase mitochondrial content in skeletal muscle and improve exercise endurance under some conditions. These findings led to popular descriptions such as an exercise mimetic, although that term oversimplifies the biology. Effects vary by dose, timing, tissue, and model. The compound's influence on circadian pathways means that time of administration can matter in experiments. Whether similar metabolic changes occur in humans remains largely unexplored in controlled published trials.
The ASA is closely related to the concept of the solvent-excluded surface (also known as the Connolly's molecular surface area or simply Connolly surface), which is imagined as a cavity in bulk solvent. It is also calculated in practice via a rolling-ball algorithm developed by Frederic Richards and implemented three-dimensionally by Michael Connolly in 1983 and Tim Richmond in 1984. Connolly spent several more years perfecting the method. Implicit solvation Van der Waals surface VADAR tool for analyzing peptide and protein structures Relative accessible surface area
Angiotensin-converting-enzyme inhibitors (ACE inhibitors) are a class of medication used primarily for the treatment of cardiovascular and kidney diseases. This class of medicine works by causing relaxation of blood vessels as well as a decrease in blood volume, which leads to lower blood pressure and decreased oxygen demand from the heart. ACE inhibitors inhibit the activity of angiotensin-converting enzyme, an important component of the renin–angiotensin system which converts angiotensin I to angiotensin II, and hydrolyzes bradykinin. Therefore, ACE inhibitors decrease the formation of angiotensin II, a vasoconstrictor, and increase the level of bradykinin, a peptide vasodilator. This combination is synergistic in lowering blood pressure. As a result of inhibiting the ACE enzyme in the bradykinin system, the ACE inhibitor drugs allow for increased levels of bradykinin which would normally be degraded. Bradykinin produces prostaglandin. This mechanism can explain the two most common side effects seen with ACE Inhibitors: angioedema and cough.
The word analgesic derives from Greek an- (ἀν-, "without"), álgos (ἄλγος, "pain"), and -ikos (-ικος, forming adjectives). Such drugs were usually known as "anodynes" before the 20th century. Analgesics are typically classified based on their mechanism of action. Paracetamol, also known as acetaminophen, is a medication used to treat pain and fever. It is typically used for mild to moderate pain. In combination with opioid pain medication, paracetamol is now used for more severe pain such as cancer pain and after surgery. It is typically used either by mouth or rectally but is also available intravenously. Effects last between two and four hours. Paracetamol is classified as a mild analgesic, and is generally safe at recommended doses. Nonsteroidal anti-inflammatory drugs (NSAIDs) are a drug class that groups together drugs that decrease pain and lower fever, and, in higher doses, decrease inflammation. The most prominent members of this group of drugs—aspirin, ibuprofen, naproxen, and diclofenac—are all available over the counter in most countries.
Sources: en.wikipedia.org
Asparagine peptide lyase are one of the seven groups in which proteases, also termed proteolytic enzymes, peptidases, or proteinases, are classified according to their catalytic residue. The catalytic mechanism of the asparagine peptide lyases involves an asparagine residue acting as nucleophile to perform a nucleophilic elimination reaction, rather than hydrolysis, to catalyse the breaking of a peptide bond. The existence of this seventh catalytic type of proteases, in which the peptide bond cleavage occurs by self-processing instead of hydrolysis, was demonstrated with the discovery of the crystal structure of the self-cleaving precursor of the Tsh autotransporter from E. coli. These enzymes are synthesized as precursors or propeptides, which cleave themselves by an autoproteolytic reaction. The self-cleaving nature of asparagine peptide lyases contradicts the general definition of an enzyme given that the enzymatic activity destroys the enzyme. However, the self-processing is the action of a proteolytic enzyme, notwithstanding the enzyme is not recoverable from the reaction.
All chemical elements derive from stellar nucleosynthesis except for hydrogen and some helium and lithium. Basic chemical ingredients of life – the carbon–hydrogen molecule (CH), the carbon–hydrogen positive ion (CH+) and the carbon ion (C+) – can be produced by ultraviolet light from stars. Complex molecules, including organic molecules, form naturally both in space and on planets. Organic molecules on the early Earth could have had either terrestrial origins, with organic molecule synthesis driven by impact shocks or by other energy sources, such as ultraviolet light, redox coupling, or electrical discharges; or extraterrestrial origins (pseudo-panspermia), with organic molecules formed in interstellar dust clouds or in the solar nebula accumulating onto the planet.
Other 1,2- and 1,3-dithiols give related 1,3-dithiolanes (five-membered) and 1,3-dithianes (six-membered rings). Diols such as ethylene glycol undergo analogous reactions to give 1,3-dioxolanes. One distinguishing feature of the dithiolanes and dithianes derived from aldehydes is that the methyne group can be deprotonated and the resulting carbanion alkylated. 1,2-Ethanedithiol has been used as a scavenger in peptide cleavage synthesis. Like 1,3-propanedithiol, 1,2-ethanedithiol readily forms metal thiolate complexes. Illustrative is the synthesis of the derivative diiron ethanedithiolate hexacarbonyl upon reaction with triiron dodecacarbonyl: Fe3(CO)12 + C2H4(SH)2 → Fe2(S2C2H4)(CO)6 + H2 + Fe(CO)5 + CO Ethane-1,1-dithiol
Sources: en.wikipedia.org
Liquid chromatography with mass spectrometry is a common approach. Ultraviolet detection and nuclear magnetic resonance can support identification when suitable standards are available.
The solid is generally kept cold, dry, and protected from light. Solutions are often frozen in single-use aliquots to reduce repeated freeze-thaw cycles.
It indicates a material sold for laboratory study, not for human use. The label does not guarantee pharmaceutical purity, sterility, or regulatory approval.
Liquid chromatography–mass spectrometry is common for identity and purity checks. High-performance liquid chromatography with ultraviolet detection can also be used. Both methods require a suitable reference standard.